Electrician in Arnold, MD

Today’s visit was for partial power loss of home. Customer had an electrician come out and they installed a dedicated circuit for the sump pump, but also disconnected the other circuit that the sump pump was originally connected to. We found the wire capped off in the panel. When we reconnected it to the panel. The first floor lights came back on, but there was still an open neutral somewhere. When I started talking to the customer about a extended diagnostic fee to find the issue, they declined and told us to turn the circuit back off. If you decide at any time for us to come back out and troubleshoot, please see the attached estimate for the diagnosis. Thank you.

Installation of customer supplied lighting fixture for the dining room.

The reason for todays visit it’s the customer was to quote adding an outlet in the basement bath, adding four recess lights located in both basement guest bedrooms, and adding dimmers to both sets of recess lights. After meeting customer, we began inspection at the panel and saw a 1979 QO 200 amp panel with many safety violations such as double tapped neutrals and double tapped breakers. We also saw that there were many dead end circuits inside the panel that are no longer being used. After speaking to the customer we then created solutions based off recommendations and what customer wanted and we provided those solutions to him at this time. Today there was no solution that fit to the customers needs and will call back in if deciding to get repairs done.

Installation of grounding/bonding to the home by way of bonding all metallic systems together by way of water heater appliance. Installation of new fan control switches for master bedroom, sons bedroom and daughters bedroom. Along with replacement of switches, removing current single gang box and turning it into a two gang box with a switch controlling the fan speed and light fixture dimmer. Installation of two new ceiling fans (customer supplied) located in the son and daughters bedroom to replace current old fans.

Arrived at the residence and was shown to the top back bedroom with a ceiling fan the resident had installed and wasn’t working. I found waygos were used for all connections but the bigger issue was that the variable speed fan where’s were all under one waygo, when according to the wiring diagram it should have come with female and male connection ends to be able to plug and play. The fan did not come with that and even when I corrected the wiring, the receiver was shorted. There is also a variable speed fan controller on the wall that turns it on and off so I recommended it be replaced with a regular white decora single pole switch to mitigate any future issues. I wrote an estimate for the switch and fan installation once they get a new one from amazon.

This solution includes the installation of 24 LED bypass tubes for the basement fixtures and garage. This solution also includes gfci protection for garage and sump pump locations. We have taken deposit and shall return July 10th 2024 We have returned and installed the led bypass tubes in the existing fluorescent fixtures. In addition we have provided gfci protection for sump pump and garage receptacles.

Installation of new GFCI located on the fourth floor inside of the loft area. Current device no longer works after power surge.

This solution includes the installation of a new dimmer switch for dining area and new switch for garage light. We have replaced the existing switch for the dining room. In addition we have replaced the switch controlling the garage light.

Installed GFCI receptacle under sink for dishwasher.

Today’s visit was for installing whole home surge protection in main panel. Work performed below: Install whole home surge protection in main panel

Installation of new customer supplied ceiling fans located on the second floor in each of the children’s bedrooms. Currently any room does not have a lighting fixture/fan and will be adding a new switch bank converting single gang to a two gang and running a new switch leg to a ceiling fan brace. This

Visit was for breaker tripping. It turned out to be the surge protector plugged into the outlet. Not a warranty call.

Today’s is it was for smoke detector. While onsite, I saw the panel was FPE. Please see quote to get this replaced should you wish to move forward in the future. Work performed today: Replace (1) combo in hallway

This solution includes the installation of a new 50A GFCI CH breaker and replacement of the premium surge protector. We have installed a new 50A gfci breaker in panel to power the EV receptacle. In addition we have replaced the damaged surge protector.

This solution includes the includes the installation of a customer supplied light fixture in the kitchen. In addition we shall install a receptacle underneath the sink for a plug in dishwasher. We have installed a new Gfci receptacle under the sink and have installed a new light fixture in the kitchen. We recommend having surge protection and water heater bonding.

I removed and replaced a pull chain keyless light fixture over washer and dryer

This solution includes the installation of a new attic fan motor, thermostat and disconnecting means. We have installed the new fan motor, thermostat and the new disconnecting means for the attic fan. We highly recommend having the incorrect breakers replaced in the main panel.

The reason for today’s visit was inquiring about replacement of current four landscape lights in the front yard. After meeting with customer, she showed me the lights and the switch that controlled them. The lights were older 120v canopy style lights with weather resistant AB square boxes in the base of them. After discussing options with the customer on exactly what she wanted, she stated there may be a point in the future where the home is sold so a budget was a concern of today’s visit. I gave the option of adding an outlet on the outside of the garage deriving power from current outlet located on the garage wall. This outlet would supply power to a weather resistant outlet with an in-use cover and also power customer supplied low-volt transformer for new customer supplied landscape lights. I also gave a quote on replacement of current switch that powers current 120v landscape lights with a “switch insert” to remove supplied power to them. At this time customer has some options on w

Today’s visit was for cold water grounding. While on site, I installed a remote for previously installed ceiling fan. Customer also asked for pricing to replace lights in kitchen and dining room. Please see attached.

Installation of new 200 amp Square D QO panel 42 slot to replace old and dated panel with multiple safety violations such as double taps. With new panel installation, updating current grounding and bonding throughout home by installing new ground rods along with new grounding wire to main panel.

Customer had just bought home and had me take a look at everything electric. The home needed a serious update on everything. See below for work performed. Replace existing panel with 40 space panel. Re-device whole home Remove and replace ceiling fan in living room Remove and replace (2) light fixtures Install (1) weather resistant GFCI in front of home

This solution includes the replacement of the existing front exterior receptacle. In addition we shall replace the 2 remaining exterior GFCI receptacles We have replaced the 3 exterior GFCI receptacles. All exterior receptacles now have wet location in use covers.

This solution includes the installation of a customer supplied fixture in the basement. We have replaced the basement fixture with new customer supplied fixture.

Was called out to look at multiple electrical issues. Customer just bought home and everything is original to the home which was built in 1978. Electrical concerns are panel rusting, devices old and backstabbed, no exhaust in two bathrooms, no ceiling fans, and no smokes in bedrooms or combos on first floor and basement. Please see attached solutions to get these concerns taken care of for you. Give us a call if you have any questions. Hope to hear from you soon! Have a great day!

This solution includes the the repair to the kitchen appliance circuit, light in kitchen, replacement of the existing breaker for disposal and appliance circuit. we shall install a new receptacle in the upstairs office area closet. This solution also includes bonding at the water heater gfci protection for laundry area, proper GFCI protection at kitchen stove area. We have restored power to the kitchen receptacles, bonded the water heater, replaced the breaker controlling the kitchen receptacles and repaired the kitchen light. We shall return next Tuesday to complete the scheduled work. We have returned and installed the receptacle in the office closet, installed GFCI protection at washing machine, re-fed the rear exterior receptacle, lastly we have installed a new wire from the light fixture over the fridge to the first recess light in the series. Kitchen light now working.