BEST Electrician Pasadena, MD – Local Electrical Contractors Near You in Pasadena

Remove all the old incandescent style dimmers on the first floor. Install a total of five dimmers in place of the old ones Replacement of all the standard toggle switches in the locations where the dimmers are being replaced Insulation of four total GFCI’s. Two of the GFCI’s in the basement will be audible with alarms for the sump pumps. Replacement of two improper breakers in the panel Installation of new water clamp for the ground wire at the main water shut off Replacement of three pull chain fixtures in the unfinished area of the basement Installation of three new wirelessly interconnected smoke detectors in the bedrooms as well as two smoke and carbon combo detectors for the hallways Installation of whole home surge protection at the main panel Replacement of 1st floor bath exhaust fan

The reason for today’s visit was to take a look at a septic pump circuit that kept tripping. When I arrived, I tested with Mr. Tim, who showed me the GFCI breaker in the main panel as well as the junction box for the septic circuit on the exterior of the home. I opened up the junction and found continuity between hot & ground, which indicated a short in the wiring. I then opened up the septic control box and detached the line side conductors from the terminal block inside, once removed from the control box, the circuit turned back on and held. There are no lock rings holding the conduit in the control box, and the conduits/knockouts on the inside had been heavily siliconed. I found evidence of major overheating radiating from the leftmost (center) conduit, which indicated that there had been enough heat damage to damage the wiring of these conductors as well as the control panel wiring. Most of the stranded terminations in the control panel are blackened and are potentially damaged as

For this call, I came out to assess a circuit tripping when 120 V EV was plugged in with no load. The circuit was fed with an old GFCI breaker out to a non-weather resistant receptacle that was rusted, secured to a rusted out box missing knockouts and an old metal cover. I replaced the breaker with a standard 20A breaker, replaced the weatherproof box with proper knockouts and installed a Weather-Resistant Tamper-Resistant GFCI with an in use cover. I also suggested Whole Home Surge Protection be added to each main panel (2), as there is none currently and is required for today’s minimum safety standards. Replace bad GFCI breaker with standard breaker Replace exterior weatherproof box Install WRTR GFCI with in use cover in new weatherproof box

Replace (2) LED retrofit in basement that fried Replace (2) basement switches

Install 3 company supplied smoke detectors in the downstairs bedrooms. Install a GFCI receptacle at the washing machine to add the correct GFCI protection. Called out today to perform annual maintenance assessment. Customer was interested in replacing old smoke detectors in the basement. While performing our assessment, we discovered that the washing machine did not have the proper GFCI protection, as well as devices throughout the home were backstabbed. Customer was aware of the backstabbed devices, and understands that these devices will eventually need to be replaced using the correct wiring methods. Customer agreed to replace the detectors and add the GFCI to the washing machine.