Electrician in Arnold, MD

Quote for panel and redevice

We have installed new exterior receptacles on the lower rear of home and dock. In addition we have installed new conduit bodies to protect wire from animals on lower deck. New in use covers have been installed as well. #review

Reason for today’s visit was to troubleshoot power loss to the family room receptacles. While going through the circuit we found that the outlets were in excellent condition and all wired properly by being screwed down on the terminals. I found that the breaker controlling the circuit labeled family room was tripped. And then found an extension cord for the Christmas tree was chewed through. Customer stated the power loss happened when the cord was plugged in for the Christmas tree. Customer threw away extension cord.

We have replaced the exterior receptacles with new weather rated devices. In addition we have installed gfci protection for the rear deck receptacles. Lower deck lighting is now working.<br>

We have restored power to the water heater, repaired the front exterior receptacle and lastly have installed gfci protection on rear of home.

We have installed gfci protection for the front exterior receptacle (fed and protected by garage gfci), the washing machine and the panel receptacle. In addition we have alleviated the double tapped breaker in panel and have installed a new dedicated breaker for the panel GFCI.

I removed and replaced two switches one controlling the master bedroom lamp upstairs the other controlling the kitchen lights I also replaced two lightbulbs for security light by garage and a lightbulb in the garage door opener I removed the ballasts in the light fixtures in the garage there were two of them then I rewire the light Fixtures so that I could install LED tubes that bypassed the ballast

We have installed a new customer supplied bath fan in the upstairs hall bathroom. In addition we have replaced the living room fan with a new customer supplied ceiling fan. Lastly we have alleviated the double tapped neutral wires in the main panel.

Customers dinning room light stopped working. Customer showed me the burnt plastic cover beneath one of the candelabra bulbs. I took the plastic cover off and noticed the socket was burnt. I then removed the dimmer and found that the burnt socket and bulb caused the dimmer to short out and stop working. I tested the wires and the light kicked back on without the dimmer attached. I installed a new dimmer switch and the light started working again. I informed customer that they will need to purchase a new light because the burnt socket was no longer usable. They are going to look into finding a new one or having this one repaired.

We have installed the new customer supplied ceiling fan in the sun room and have alleviated the double tapped neutral wires in the main panel. In addition we have installed 2new exterior receptacles on the outside of sun room.

I ran a 1 inch pvc pipe from main electrical panel to outside then up the wall to install a RV sub panel Ran a 50 amp line with 6 wire so if the customer ever decided to up grade they will have the ability to do so without running other size wires We will return Friday 8-5-2022 to complete the work Installed tv sub panel

I removed and replaced a ceiling fan in living room with a customer supplied ceiling fan and installed a new single pole switch also put blank plates on 2 cable boxes

I measured out all the rooms and found the center of the rooms and marked the ceiling with painters tape Then after confirming with the customer this is where they’d like the ceiling fans In the master bedroom I cut out a whole and installed a fan brace box. I ran a 14-3 wire from the box into the attic then down into a existing switch box I had to re wire and replace the switch control receptacle so I could get 120 volts in the switch box. Then i installed a customer supplied ceiling fan. I also installed a company supplied in wall fan switch control system We will return to complete the rest of the rooms July 20th 2022 July 20th I cut out the holes in the center of two bedrooms and installed fan rated ceiling boxes then ran my 14-3 wire in the attic and down inside the walls where the existing switch boxes are. Then I installed 2 customer supplied ceiling fans. I installed two in wall fan switch controls. Tested the fans and everything works I replaced a damaged receptacle

I removed and replaced a customer supplied light fixture out front of home by the front door I located and repaired a broken wire for low voltage landscape lights going up to the front steps I then removed and replaced 6 landscape lights going up to the driveway. Customer supplied Tested

I ran a 14-3 wire from the center of the ceiling in master bedroom up into the attic and down to an existing switch I installed a fan rated tension mounted box Then installed a customer supplied ceiling fan with remote I removed and replaced the switch controlling the fan. I also noticed a damaged receptacle in the master bedroom and replaced it with a tamper resistant receptacle. (No charge ) I also fixed a box for the whole house fan which was sitting too far out of the wall Also strapped the seu cable back up the wall but explained too the customer the previous home own zip tipped it back up due to the tension relief I hook being damaged off the wall outside and sent customer a quote to replace the seu cable and upgrade to a 200 amp service

Replace chandelier in foyer 13ft. Replace switches for chandelier. Replace bath fans in hall bath. Replace bath fans in master bath.

Replaced lights and switches throughout house. Replaced switch for dining room with dimmer switch. Rewired 3-way switches to work correctly. Replaced post light and front porch light. Replaced patio light for backyard.

Replace chandelier in dining room with customer supplied. Troubleshoot microwave tripping breaker (bad microwave plugged microwave into another circuit and it blew and saw sparks and flash come from microwave when it was turned on.)

Install ceiling fans in 3 bedrooms.

I ran 3 new circuits from a sub panel in the spare house down into a crawl space under the home out the side of the block wall I ran 3 12-2 UF cables 2 of them are for 20 amp circuits and 1 of them is for a 15 amp circuit and I labeled the wires so the well installers will know which is which outside rolled up. They will trench the wire and everything from the panel to the side of the house will be warrantied for 6 months I landed the wires in the panel on Homeline breakers and labeled the panel I pvc piped out the side of the home with a LB then used a piece of pvc then can slide up and down so when the dirt is put back over time it doesn’t rip out of the wall

Installed new customer supplied camera door bell at the front door. I ran customer supplied cord with transformer down to the unfinished closet underneath the foyer and installed a new outlet for transformer to plug into. Replaced broken pull chain fixture in the laundry area and replace loose outlet in the master bedroom behind the tv.

I ran a 1 inch pvc pipe from the main electrical panel outside down the side of the house and on the back porch to a 50 a,pump gfci spa pack disconnect. Then from there I ran a pvc pipe into the hot tub, changed over to seal tight to the electrical box in the hot tub. I then ran #6 THHN in the pipes and made all the electrical connections. In the panel I installed a tandem 20 amp qo breaker to make space for the hot tub. The panel is rated for it. I then installed a 50 amp 2 pole qo breaker for the hot tub. Tested it and everything works Customer has a 1 year warranty

Customer had a loss of power in bathroom downstairs and other basement rooms I found a Junction box someone covered with drywall in the ceiling in the downstairs bedroom. In that box the neutral was disconnected from the splice. I replaces that splice and multiple splices in the circuit Customer has a 30 day warranty

This estimate includes the installation of a whole home surge protector. We have installed a new whole home surge protector, ULTRA. In addition we have checked the gfci controlling the sump pump. We have determined that the motor should be checked by a qualified plumber.