Catonsville MD Electrician Services

This solution includes the replacement of the existing damaged service cable, updates to grounding and bonding, labeling the panel, exterior disconnect, gfci breakers to protect the ungrounded receptacles, installation of properly rated breaker for panel, bonding screw for panel and permitting and inspections. This solution includes a premium whole home surge protector.

We were called out today to examine the overhead service line sheathing. We noted significant deterioration of the wires sheathing upon visual examination. After examining the line more we moved inside to examine the panel. The panel was newer but included violations such as double tapped neutrals and shared neutral circuits. We also noticed significant damage on the interior feed line, this damage actually temporarily disabled power during our visit but started working again after being wiggled. In addition, the meter on the inside is significantly damaged. It looked like someone used an hammer to pry it open. Outlets are original to the home and some were missing grounds upon inspection. After doing a whole home inspection we began writing our quotes. We provided two quotes to the client, the first quote uses the 100 AMP panel that is currently in the home and the second quote includes an upgrade to a 200 AMP panel. At this time customer has not signed on to proceed, he wanted time t

Today’s visit was for ceiling fan and receptacle not working. During assessment, I saw ceiling fan would need a three wire for light and fan motor to operate separately. The receptacles were backstabbed and the wires coming out of the receptacle was loose and exposed. This cause the receptacle to stop working. Please see below for work performed to resolve this. Install new switch leg for ceiling fan Replace all devices on second floor for master bedroom and spare room circuit

We have delivered pricing regarding both the service cable replacement and receptacle grounding issues.

Today’s visit was for miscellaneous work around the home. Please see below for work performed. Replace exterior GFCI not working Install new exterior GFCI getting power from receptacle inside Install new GFCI on perm post in front of home using UF wire from deleted lamp post

Installation of new GFCi located on kitchen counter top next to stove where current device does not reset properly causing power loss.

This solution includes the installation of a customer supplied EV charger on wall at bottom of driveway. In addition we shall replace the 2 damaged GFCI receptacles. GFCI locations ar kitchen and exterior at front door. We have replaced the kitchen gfci. We shall return when the customer supplied EV charger arrives to complete exterior work. We have returned and completed the installation of the customer supplied charge point EV charger.

This solution includes the installation of the 2 customer supplied exterior fixtures. WE have installed the customer supplied fixtures at the front door and side door. In addition we have installed a rated box for the front exterior fixture.

This solution includes the installation of 5 standard hardwired sealed battery detectors and 2 combo detectors. We have installed the new smoke and carbon monoxide detectors.

Installing 3 new hardwired smoke detectors in home. One unit on the top floor in the hallway, 2nd unit in the living area near the closet door and the 3rd unit is in the basement near the entrance to the unfinished area. 9/29 returned today and installed the three hardwired interconnected units.

I removed the existing seu cable and installed a new 4/0 seu cable for the existing 200 amp service main electrical panel I installed two 8 foot ground rods outside 6 feet apart then ran a number 4 bare copper wire to them and into the electrical panel I then ran a number 4 bare ground wire from the panel to the water entrance and bonded the gas pipe to the water heater water pipes I removed two multi feed 15 amp breakers and installed two pole breakers as per code requires I installed a emergency disconnect I ran 4/0 seu cable from the disconnect to the meter and temporary spliced the wires together I installed a whole home surge protector Customer has a 6 month warranty

WO-TNFR77624 Customer has 2 original 50 cfm bathroom exhaust fans that are not properly working properly and are not vented out the attic. We will be installing 2 new Haas and sons supplied Panasonic quiet type fans in lace of existing fans in the the 2nd floor bathrooms. We will be installing new through the roof vent outs with new 4inch venting from fans to new vent caps. 7/14 Returned today and completed scoped work. We removed the 2 original 50 cfm bathroom exhaust fans and installed new Panasonic quiet type select a speed fans in their place. We set both fans to 110 cfm because both fans have showers. We installed new roof top goose neck vent outs with dampers that close when fan is not in use. We ran 4” flex venting from new fans up to the new vent outs. Once installed we tested both fans and they are working properly.

I removed a junction box that was screwed to the floor under the dishwasher in the kitchen. The feed was coming through the floor So I ran a new multi feed circuit from the main electrical panel through the utility room up into the kitchen under the sink then pvc piped it for better protection into a 1900 box. I then re fed the garbage disposal switch which only had a 14-2 wire to it. I replaced it with a 14-3. I installed a QO arc fault 2 pole 15 amp breaker And I installed 2 gfcis under the sink. I then put a company supplied cord on the garbage disposal and a customer supplied cord to the dishwasher. I tested the garbage disposal but not the washing machine as it wasn’t hooked up to the water line yet Customer has a 18 month warranty Labeled circuits on panel

Customer called to install a chandelier I installed a customer supplied chandelier on a 18 foot ceiling in the main foyer The box in the ceiling was recessed to far in the drywall so installed a spacer box so the bracket for the chandelier would be tight to the ceiling giving it the best support I also removed and replaced 4 three way switches (existing switches are original to the home) Inside the electrical panel I noticed many multi feed wires on single pole breakers So I removed them and installed two pole breakers for these circuits I also installed a whole home surge protector Customer has a 18 month warranty on work preformed

Removed old ceiling light and installed new surface mounted ceiling fan in front bedroom.

This estimate includes the repair of the exterior receptacles on the back deck near grill and closest to door. This estimate includes the installation of a universal remote for the ceiling fan. This estimate includes the installation of a customer supplied light fixture in the room upstairs. We have repaired ceiling fan, installed Gfci protection for exterior receptacles and installed a customer supplied light fixture in the spare room upstairs.

Replace existing exhaust fan with customer supplied exhaust fan. Replace duplex switch for fan and light.

This estimate includes the installation of a new Gfci receptacle and securing of the box. We shall return next Wednesday to remedy the kitchen lighting. This estimate includes the partial rewire for the kitchen recess lights. We shall ensure that the kitchen recess lights are no longer affected by the ceiling fan in the living room, and likewise the ceiling fan in living room is not associated with the existing dimmer switch. We have completed the partial rewire of the kitchen recess lights. Lighting now operating without interference on the ceiling fan.

Upon arrival I spoke to the customer and we talked about replacing the chandelier in the dining room. After talking for a little we decide to replace the chandelier and install a dimmer switch. Upon completion of job it was noted that the medallion for the light would not sit flush to ceiling due to ceiling not being level and there only being two screws holding it up in the middle. Informed customer of this and customer said it’s fine, and they would take care of it.

After looking at panel, which is new, we believe that the intermittent power and surges are stemming from a possible BGE issue. In addition we have found no faults in the garbage disposal circuit, we recommend a new breaker if problem continues. Lastly we have delivered several estimates.

This estimate includes the installation of a new customer supplied bath fan motor. We have replaced the existing bath fan motor.

Installed 8 4 inch recess wafers in basement on dimmer using switch legs from old lights. Installed a new 20 amp circuit in washer area. Circuit is afci protected and has a gfci receptacle. Installed 2 new coax lines 1 in bedroom and 1 in workshop.

This quote is for the following work. -remove fan in dining room and install a customer provided chandelier in its place with a new dimmer -remove and replace fan in bedroom and replace switch(customer provided fan) -gfci protection in kitchen -replace a loose receptacle in basement -remove and replace 2 outdoor receptacles and covers -check basement lighting connections Verified proper operation of all competed work with customer.

E have replaced the existing decora combination switch and GFCI in the master bathroom.

Installed 3 new quad receptacles in workshop on 2 20 amp circuits. Each box with receptacles ha one on each circuit. Verified proper operation of all completed work with customer.